Scroll Bench

Saws & blades

Compare throat space, blade mount and the material you intend to cut.

Scroll saws

Arc Sixteen

Arc Sixteen
plain / pinned blade holder

Machine working range

Timber selection limit
35 mm
Internal pierced cuts
Plain-end holder available

A compact variable-speed bench saw for pierced shapes and close curves in dry wood sheet. The 406 mm throat describes the distance behind the blade, not a promise about every workpiece. Plain-end or pinned 127 mm blades can be fitted to the stated holders. A tilting table supports bevel work while the front hold-down keeps a small panel close to the surface.

Scroll saws

Arc Twenty

Arc Twenty
plain blade holder

Machine working range

Timber selection limit
50 mm
Internal pierced cuts
Plain-end holder available

A deeper-throat scroll saw for larger decorative panels, with an upper arm that lifts to thread a plain-end blade through a pilot hole. Its 508 mm reach leaves more room behind an internal cut. Blade choice, timber and feed pressure still determine the useful cut; the capacity figure is a clearance limit rather than a guarantee of finish.

Blades

Plain-End Detail Blades

Plain-End Detail Blades
plain blade holder

Blade-pack selection

Timber selection limit
20 mm
Internal pierced cuts
Plain-end holder available

A twelve-piece pack of plain-end 127 mm blades for a compatible scroll-saw clamp. The fine tooth profile suits controlled curves in thin dry timber. A plain end can pass through a small pilot hole before the clamp is closed, which is useful for interior shapes. Check the holder type and blade length on your actual saw before selecting the pack.

Blades

Pinned General Blades

Pinned General Blades
pinned blade holder

Blade-pack selection

Timber selection limit
25 mm
Internal pierced cuts
Not selected for pierced work

A twelve-piece pack of pinned 127 mm blades for saws with pin supports. The cross pins locate in the holder and need a larger entry hole than a plain blade for inside cuts. These are separate consumables, not an adaptor for a plain-only clamp. Match the stated end style, working length and intended material before use.